Fig100

Main Types:
Hammer Union type mainly consists of Figure50, Figure100, Figure200, Figure206, Figure207, Figure400, Figure600, Figure602, Figure1002, Figure1002 and Figure1502.

Fig200/206

Fig200 206 Hammer Union
These hammer unions are best suited for medium pressure ranges involving air, water, oil & gas service for cold working pressure up to 2,000 PSI. Up to 4″ no O-ring is used on the male sub.

Fig207

Product Description:
Fig207 Blanking Caps and hammer unions are fully interchangeable with Fig200 and 206 hammer unions. For use where the blanking off at the end of a line is desirable. The cap is fitted with an ‘O’ ring to ensure a leakproof seal.

Fig400

These hammer unions are rigid in design and have all the three parts made of steel forgings. These hammer unions are best suited for manifold and line connections. Hammer unions from 3 inch through 8 inch sizes have O- rings for primary sealing. From 5″ to 8″ sizes C.W.P. is 2,500 PSI.

Fig602

Raw Material:
Low Carbon Steel (EN 1A, SAE 1020, SAE 1010 etc.)
Medium Carbon Steel (EN 8, EN 31, EN 9, SAE 1045 etc.)
Stainless Steel (SS304, SS310, SS316 etc.)

Fig1002

Main Types:
Hammer Union type mainly consists of Figure50, Figure100, Figure200, Figure206, Figure207, Figure400, Figure600, Figure602, Figure1002, Figure1002 and Figure1502.

Hammer unions are one of the most readily used connections in the oil and gas industry. Hammer unions are suitable for pressures up to 20,000 psi, and all have full material traceability.

All components are subjected to rigorous inspection checks throughout the manufacturing process to ensure a quality product every time.

Hammer unions are approved and used by major service companies, drilling contractors, and operators around the world.

All connections are clearly marked to show the nominal size, figure number, working pressure, and service (sour or standard).