Butt weld hammer union manufacturer
Fig100
Main Types:
Hammer Union type mainly consists of Figure50, Figure100, Figure200, Figure206, Figure207, Figure400, Figure600, Figure602, Figure1002, Figure1002 and Figure1502.
Fig200/206
Fig200 206 Hammer Union
These hammer unions are best suited for medium pressure ranges involving air, water, oil & gas service for cold working pressure up to 2,000 PSI. Up to 4″ no O-ring is used on the male sub.
Fig207
Product Description:
Fig207 Blanking Caps and hammer unions are fully interchangeable with Fig200 and 206 hammer unions. For use where the blanking off at the end of a line is desirable. The cap is fitted with an ‘O’ ring to ensure a leakproof seal.
Fig400
These hammer unions are rigid in design and have all the three parts made of steel forgings. These hammer unions are best suited for manifold and line connections. Hammer unions from 3 inch through 8 inch sizes have O- rings for primary sealing.
Fig602
Raw Material:
Low Carbon Steel (EN 1A, SAE 1020, SAE 1010 etc.)
Medium Carbon Steel (EN 8, EN 31, EN 9, SAE 1045 etc.)
Stainless Steel (SS304, SS310, SS316 etc.)
Fig1002
Main Types:
Hammer Union type mainly consists of Figure50, Figure100, Figure200, Figure206, Figure207, Figure400, Figure600, Figure602, Figure1002, Figure1002 and Figure1502.
Contact Us